Chapter 8: Installing Optional Ports
Summit Family Switches Hardware Installation Guide
336
Installing a Versatile Interface Module in a Summit
X480, X650, or X670 Series Switch
This section describes how to install VIM1, VIM2, VIM3, and VIM4 versatile interface modules (VIMs).
The installation procedure is the same for all VIMs in Summit X480, X650, and X670 series switches.
You need the following tools and materials to install a VIM:
● ESD-preventive wrist strap
● #1 Phillips screwdriver
CAUTION
Summit VIMs are not hot-swappable. Disconnect power to the switch before removing an installed VIM or
installing a new VIM.
To install a versatile interface module:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Disconnect the switch power.
3 Remove the cover plate from the VIM slot:
a Remove the retaining screws at the top corners of the cover plate or module, and set the screws
aside in a safe place.
Save the retaining screws to secure the new module in the switch.
b Pull the cover plate away from the module slot (Figure 282).
Figure 282: Removing a VIM Cover Plate
4 Remove the new VIM from its anti-static packaging.
SH_150
To Next Page
Loading...
