Extreme Networks Summit X460 Series User Manual

Installing AC Power Supplies in Summit X460 Series Switches
Summit Family Switches Hardware Installation Guide
247
Installing a 750 W AC Power Supply in a Summit X460 Series
Switch
WARNING!
To prevent an electrical hazard, make sure that the AC power cord is not connected to the power supply
before you install the power supply in the power supply bay.
CAUTION
Make sure that the AC power supply circuit is not overloaded. Use proper over-current protection, such as
a circuit-breaker, to prevent over-current conditions.
To install a 750 W AC power supply in a Summit X460 series switch:
1 If necessary, remove a blank panel from the back of the Summit X460 series switch (Figure 186).
Figure 186: Removing a Blank Panel
2 Verify that the power supply is right side up (see Figure 187).
3 Carefully slide the power supply all the way into the power supply bay (see Figure 187). Push the
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
SH_204

Extreme Networks Summit X460 Series Specifications

General

Brand	Extreme Networks
Model	Summit X460 Series
Category	Switch
Language	English