Extreme Networks Summit X460 Series - Installing an Option Card in Slot B of a Summit X460 Series Switch

Installing an Option Card in Slot B of a Summit X460 Series Switch
Summit Family Switches Hardware Installation Guide
335
Installing an Option Card in Slot B of a Summit X460
Series Switch
In the Summit X460 series switch, a stacking module or XGM3SB-4sf option card can be installed in
Slot B on the back panel of the switch.
To install an option card in Slot B:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 At the back of the switch, remove the cover from Slot B (Figure 280).
Figure 280: Removing the Slot B Cover
3 Carefully slide the stacking module all the way into the slot (Figure 281).
4 Align and fully tighten the captive retaining screws.
Figure 281: Installing a Stacking Module (SummitStack module shown)
SH_216
SH_217