Extreme Networks Summit X460 Series - Removing a Summit X670 Series Switch

Chapter 13: Removing a Summit Family Switch from a Rack
Summit Family Switches Hardware Installation Guide
398
Removing a Summit X670 Series Switch
Before you remove a Summit X670 series switch from a rack, remove all installed power supplies as
described in the following sections:
● “Removing a Summit 450 W or 550 W AC Power Supply” on page 388
● “Removing a Summit 450 W or 550 W DC Power Supply” on page 389
Removing the Switch from the Rack
To remove a Summit X670 series switch from an equipment rack:
1 Verify that the power supplies have been removed from the switch.
2 Support the switch as you remove the screws that hold the switch to the rack.
3 Slide the switch out of the rack.