Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
264
5 From the front of the rack, slide the switch onto the rear mounting brackets (Figure 210).
Figure 210: Installing the Switch—Four-Post Installation
6 Slide the switch all the way into the rack and secure the mounting brackets to the front posts using
suitable screws (Figure 211).
Figure 211: Securing the Switch to the Front Rack Posts—Four-Post Installation
After the switch is secured to the rack, install and connect power supplies as described on page 265 for
AC power supplies or on page 268 for DC power supplies.
NOTE
If you are installing a VIM2 module, install it in the switch before you connect the switch to power.
SH_146
SH_147
To Next Page
Loading...
