Extreme Networks Summit X460 Series - Page 379

Replacing a Versatile Interface Module (VIM) in a Summit X480, X650 or X670 Series Switch
Summit Family Switches Hardware Installation Guide
379
Figure 322: Removing a VIM (VIM1-SummitStack Module Shown)
4 Remove the replacement VIM from its anti-static packaging.
5 Install the replacement VIM in the switch (Figure 323):
a Make sure the inserter/ejector levers are rotated down.
b Carefully slide the module into the switch until the inserter/ejector levers begin to rotate upward.
c Simultaneously rotate both levers upward to seat the module internal connectors.
d Insert and tighten the retaining screws you removed earlier.
SH_092