FARO Gage
May 2011
57
Chapter 7: Configuring the FARO Gage in CAM2 Gage
Hole Method - Guidance
Perform the Hole compensation using the FARO probe compensation cone. If the
G
UIDANCE check box is selected for the current probe, use the following steps.
See “Edit Probe” on page 55.
Collect all of the points in this method by holding down the FRONT button. The
Gage will collect points as fast as possible (“scanning”) until you release the
Figure 7-3 Hole Method
Position #1
Position #2
Position #3
08M47E00_FAROGage.book Page 57 Wednesday, June 8, 2011 4:12 PM
To Next Page
Loading...
