C-3
1 The training class will prepare attendees to successfully attain an
operators certification (see Certification Requirements section for
more details).
2 The fee schedules for advanced additional training courses can be
obtained from Customer Service, or the Sales department.
Certification Requirements
The Gage operator’s inherent ability to understand 3D concepts may be
in their background training. However, the precision with which the
operator performs 3D measurements with the Gage is critical in
establishing the accuracy and repeatability of the results of subsequent
measurements.
In order to establish the proficiency of Gage operators, FARO has
instituted an Operator Certification program, where each operator’s
knowledge and understanding of the Gage is evaluated. The successful
operator is awarded a certificate which identifies him/her as an
accredited Gage operator. The requirements are as follows:
1 Attend a FARO-conducted basic training course, either at a FARO
Facility or on site at your facility.
2 Certification will be awarded once the class has been completed, and
then the certified user will be registered for hardware and software
support.
To certify an operator, call FARO’s Training Department, 800.736.0234
(North America), +1 407.333.9911 (Worldwide), for updated
information.
Gage Repair Fee Schedule
(Out of Maintenance/Warranty Owners Only!)
System Testing and Evaluation Fee - Contact your local FARO
Service Center for pricing.
A fee is charged for any system testing and evaluation. This includes
system diagnosis, calibration and/or recertification, and applies to all
Gages. However, this fee does not include disassembly/repair costs if
required. An estimated cost for disassembly/repair will be given to the
customer prior to the repair. The disassembly/repair charges must be
08M47E00_FAROGage.book Page 3 Wednesday, June 8, 2011 4:12 PM
To Next Page
Loading...
