OPERATION ST100 Series Flow Meter
20 Fluid Components International LLC
Verify Engineering Units
Verify that the engineering units are correct for flow rate, temperature (and pressure is equipped). Use the HMI to make any necessary changes.
The basic functions accessible from the HMI menu are listed in the outline below. For expanded configuration options use the ST100 configuration
software application.
System Faults, Alarms and Logging Indication
The ST100 HMI indicates System Faults, Alarms and Logging by displaying three different icons when these conditions are present. These icons
appear directly above the flow rate indication on the main process data screen. FAULTS are displayed as a Caution Triangle icon, ALARMS as a Bell
icon and LOGGING as a LOG icon.
Figure 16
Log, Alarm and Fault Icons
To Next Page
Loading...
