Page 20 of 91
PART 4
ABOUT PROGRAMMING
4.1 CONTROLS AND INFORMATION
The EN-54 norms supplies two level of access for the control panel user. The access levels of the user are
defined as shown previously:
Level 1
All the information reads operative, the control panel controls are disabled.
The access to the superior level is obtained typing in a numerical code through the numerical keyboard.
Level 2
All the information and controls of the control panel are operative. In this level the system configuration cannot be
modified. However it is possible to activate or disable zones or sensors to modify time and date. The access to
level 3 is obtained typing in a numerical code through the keyboard. After a previously programmed time has
passed, the system will go back to level 1 automatically.
4.1.1 Control panel controls
Main control keys:
Silence Silence the internal buzzer.
Reset Delete all the alarm conditions and rearm the control panel.
Menu Access to auxiliary menu.
Besides there are other keys to enter the different functions.
1,2,3,4,5,6,7,8,9,0 Insertion of the numbers from 0 to 9 and the letters from a to z.
Arrow up Advance up wards of the selection.
Arrow down Advance down wards of the selection.
Left arrow Advance left wards of the selection.
Right arrow Advance rightwards of the selection.
Menu Main menu input.
Sel. Select.
Pre. Preceding.
Sub. Subsequent.
Mod. Modify.
Ok To confirm modification.
Scheme of the associations between numerical and alphanumeric push-buttons:
MODALITY
KEY “123” “abc” “ABC”
1 1 a b c A B C
2 2 d e f D E F
3 3 g h i G H I
4 4 j k l J K L
5 5 m n o M N O
6 6 p q r P Q R
7 7 s t u S T U
8 8 v w x V W X
9 9 y z space Y Z SPACE
0 0 space . space SPACE . SPACE
To Next Page
Loading...
