FDP EX-CPL - 11.6 CHRONOLOGICAL RESET

Page 60 of 91
Rev. 4.
2
0
11.6 CHRONOLOGICAL RESET
This function physically deletes all memorized chronological events. The command “remove”, in the event menu
(see chapter events 4.6.2), limits itself to simply trace the event as cancelled; recovery the information may be
obtained through the maps management programme which, once initiated, downloads all the events (including
the ones previously eliminated with function “remove”).
CAUTION: once the chronological reset is confirmed, the Control Panel will re-start with the “System Fault” mode;
thus press the command button “Restore System Fault” located on the electronic circuit board for the restore. If
there were Loops in service; they will be automatically restored into their original function – in the “Restore Fault”
situation it is not necessary to wait for the Loop re-start.