FENDT MAN D 0836 LE - Page 99

Fav 900
Engine / Short block
Removing and refitting con-rod
G
Repair
Fav 900 chassis number 23/3001 and up
21.2.2001
2210 000009
G
a
4/5
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting con-rod
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Press out piston pin, securely holding the piston.
Remove piston and depose it safely.
Note:
If the con-rod needs replacing, use ready-to-fit
new bush or reconditioned con-rod.
PMTAB_Picture
Measuring big-end con-rod bore
Screw on con-rod bearing caps (without bearing
shells).
Mesure bore diameter with an internal
micrometer.
Replace con-rod if this is in excess of the
permissible variation.
PMTAB_Picture
Refitting piston to con-rod
Fit piston to con-rod, inserting piston pin, and fit
circlips.
PMTAB_Picture
When reassembling, make sure that piston,
con-rod and cooling oil nozzles are assembled
correctly.