Ferno XT PRO - Page 47

47
© Ferno s.r.l. Rel.05042024
XT Series Extrication Devices
The head fastening procedure ends with the positioning of
the chin strap (Figure 71).
At this point, the operator manually holding the person’s
head can stop, as their head will be rmly secured to the
XT MILITARY, and the operator will be free to perform the
subsequent manoeuvres.
Extend the chest restraints completely and pass the male
end diagonally across to the opposite side (where the other
operator may be) by sliding the restraints over the shoulders
(Figures 72 and 73).
Figure 71 - Complete head fastening with chin strap
Figure 72 - Grabbing the chest restraints
Figure 73 - Extending the chest restraints
Fasten the buckles so that the chest restraints cross over the
chest, respecting the colour codes on each buckle (Figures
74 and 75).
Figure 74 - Fastening the chest restraints
Figure 75 - Correct position of the chest restraints