Ferno XT PRO - Spare Parts Assembly; 9 Technical Support

81
© Ferno s.r.l. Rel.05042024
XT Series Extrication Devices
9  TECHNICAL SUPPORT
WARNING
Non-original spare parts and inadequate repairs
may cause damage and/or injury. Use only original
Ferno spare parts and refer exclusively to Ferno
S.R.L.'s Customer Support.
WARNING
Unauthorised modications of the XT extrication
device could cause serious damage, injury and/or
unforeseeable operating problems. Do not modify
or alter the device in any way.
Ferno Technical Support
Customer Service and Technical Support are important aspects of
every Ferno product. Before contacting us, note the serial number
of the product and specify it in all written communications. For
all queries concerning technical support, contact Ferno S.R.L.:
E-mail assistenza.it@ferno.com
Website dedicated to support - Ferno SOS www.fernosos.it
Phone 0039 0516860028
Phone (toll-free for Italy) 800.501.711
Ferno S.R.L. is authorised to carry out preventive and corrective
maintenance (repairs) on all Ferno products in exclusivity.
Any corrective action must necessarily be carried out by Ferno
personnel and the operations must be carried out using original
spare parts. In this way, the warranty is also extended to the
components involved in the operation.
Any corrective action carried out by non Ferno personnel will
automatically cancel any Civil Liability insurance and any
guarantee.
8.2.1 Spare parts assembly
Please refer to the spare parts list in the Spare parts chapter in this manual.
ASSEMBLY OF REINFORCING SLOTS OF THE PRO KIT
If you purchase a PRO KIT, you will need to install the reinforcing slots for the lifting strap on the board.
To do this, place the pair of red reinforcements on the upper and lower surfaces of holes 3 and 14, mating the slot with the
screw slot on the upper side, i.e. the side where the QHI is glued. Then apply a drop of threadlocker to the two xing screws
and tighten them as shown in the image below, ensuring that the two reinforcements are rmly xed to the board.
Figure 137 - Assembling the reinforcing slots of the PRO KIT