56
© Ferno s.r.l. Rel.05042024
XT Series Extrication Devices
6.3 - XT Floating extrication device assembly
6.3.1 QHI (Quick Head Immobilizer)
assembly
The Quick Head Immobilizer must be applied before using
the XT FLOATING extrication device.
1.Before its application, make sure that the extrication
device is placed on a at surface and the part where the QHI
head immobilizer will be applied is clean and dry.
2. Peel off the sticker lm placed under the QHI, ensuring
that the Velcro stays on the QHI (Figure 99A).
3. Centre the QHI (Figure 99B) on the upper part of the
extrication device, close to the head end hole no. 1, (to
identify the hole no. 1, see the XT Floating components
paragraph).
4. Press the QHI so that its sticker perfectly adheres to the
surface (Figure 99B).
Once the QHI has been correctly applied, it will be possible
to use the Velcro to detach and attach the cushion during
cleaning and disinfection or as required.
Figure 99 - QHI application
99A
99B
99C
To Next Page
Loading...
