58
© Ferno s.r.l. Rel.05042024
XT Series Extrication Devices
103A 103B
Once this is completed, x the excess strap inside the adjacent buckle (Figures 103A and 103B).
Repeat the operation described for the side fastening points,
using slots 3 and 14. Always block excess tape, as shown in
Figures 101, 102, 103A and 103B.
WARNING
For correct assembly, the strap must be tensioned
as tightly as possible, respecting all the steps.
Figure 103 - Head-end oat correctly assembled
103C
To Next Page
Loading...
