69
© Ferno s.r.l. Rel.05042024
XT Series Extrication Devices
Fasten the female buckle located between the two oats
with the male buckle on the groin restraint.
Adjust the groin restraint.
Secure the head with the triangular head immobiliser,
placing it on the patient's forehead at eyebrow level and,
holding the triangle in place with one hand, tension the
lateral straps rst and then the central strap.
WARNING
It is important that the black restraint is well
stretched, so as to ensure a rst immobilisation
(although partial) and, above all, allow the patient
to oat.
Important
It is important that the triangular head immobiliser
is well tightened to guarantee the cervical spine
alignment.
Normally, the head is well restrained by just using the
latter.
If it is deemed necessary, we recommend the
application of the neck brace before the application of
the triangle. In this case, the immobilisation can also
be completed with the application of a chin strap.
Proceed with closing the transverse restraint on the pelvis
with the red buckle. This restraint must be well stretched.
Release the black buckle of the main oats rst and place
the oats on the patient's chest.
Figure 127 - Positioning the oats on the chest
Figure 128 - Black restraint fastening
Figure 129 - Black restraint tensioning
Figure 130 - Triangular head immobiliser application
Figure 131 - Red restraint fastening
To Next Page
Loading...
