2 Assembly instructions
© Festo Didactic 759614
11
Note
Further information on assembling or disassembling the controller or individual extension modules
can be found in the manuals of the respective controller manufacturers.
2.1.3 Siemens
– Assembly:
1. Establish a connection with the other modules by inserting a bus connector into the CPU
(see picture detail).
2. Mount the CPU (1).
3. Push the CPU over as far as the left-hand module (2).
4. Now tilt it downwards (not before) (3).
5. Hand-tighten the modules onto the mounting rail.
6. If you are using a CPU with MMC, insert this into the module slot.
7. You must assemble one digital input module and one digital output module on the right beside the
CPU. To do this, repeat steps 1 to 6.
Note
Only the internal power pack, the ER power pack or the tabletop power pack from Festo Didactic
may be used. Any other power packs are impermissible.
Note
Further information on assembling or disassembling the controller or individual extension modules
can be found in the manuals of the respective controller manufacturers.
To Next Page
Loading...