A. Technical appendix
A-4
Festo P .BE-MPA-EN en 1108e
General
Materials
– Valve, sub-bases, supply plates and end plates
– Electronics module
– Multi-pin plug connection
–Seals
– Cover of the proportional pressure regulator
Al
POM/polycarbonate
Polyamide 6
Elastomer, NBR
PAXMD6-GF50/gr-P; PA6-GB20, GF10/gr-P
Weights (in g):
– Pneumatic interface or multiple connector plate
(with exhaust plate/flat plate silencer)
– CPI sub-base (with exhaust plate / flat plate silencer)
– AS interface (with exhaust plate / flat plate silencer)
– Per sub-base (with seal, electronics module,
electrical interlinking, inscription label holder,
screws)
– Per pneumatic supply plate (with seal, electrical
interlinking, screws, exhaust plate / flat plate
silencer)
– Per electrical air supply plate (with seal, electrical
interlinking, screws)
– Per pressure sensor plate
– Per propo rt ional pressure regulator with sub-base
and electronics module)
– Per complete CPX module
– Left-hand end plate (CPX terminal)
– Right-hand end plate ( M PA-S)
324 g/315 g
427 g/418 g
396 g / 360 g
185 g
120 g/111 g
200 g
200 g
approx. 57 5 g
approx. 21 0 g
approx. 80 g
55 g
MPA1 MPA2
–Pervalve
–Percoverplate
– Per pressure regulator plate
approx. 56 g
24 g
100 g
approx. 100 g
44 g
180 g
Tab. A/1: General technical data
To Next Page
Loading...
