B. Supplementary component summary
B-15
Festo P.BE-MPA-EN en 1108e
Mounting Proceed as follows:
1. Make sure the seals are not damaged. Replace the seals if
they are damaged.
2. Place the seal onto the guide pins of the pneumatic
interface.
1 Guide pins
2 Pneumatic
manifold blocks
3 Seal
4 Pneumatic
interface
1
234 1
Fig. B/3: Mo unting the MPA-S valve terminal to the pneumatic interface
3. Push the pneumatic interface together with the pneumatic
manifold blocks. Make sure that the seal and the
components are correctly positioned.
To Next Page
Loading...
