1. Summary of components
1-39
Festo P.BE-MPA-EN en 1108e
Information on the electric connecting and display elements
of the CPX bus node can be found in the corresponding
electronics description (see system manual for your CPX
terminal, table “Descriptions of the CPX terminal”).
Information on the electric connecting and display elements
of the CPI module can be found in the leaflet supplied with
the product.
Additional information on the LEDs of the electronic modules
VMPA...-FB-EM...-... is provided in the MPA-... electronics
description.
1.6.1 Pressure sensor plate
The pressure sensor plate has the following display elements:
1 Pressure sensor
plate
2 Red LED:
Pressure
exceeded
3 Green L ED:
Pressure
conformed to
4 Red LED:
Pressure
too low
5 Red LED:
Common error
display
1
2
3
4
5
Fig. 1/19: Display elements of the pressure sensor plate
To Next Page
Loading...
