Sorting Station Inline
© Festo Didactic 8129444
17
CAUTION
Pneumatic circuit setup
– Connect the components with plastic tubing with an outside diameter of 4 or
6 mm.
– Push the tubing as far as it will go into the push-in connector.
Pneumatic circuit dismantling
– Switch off the compressed air supply before dismantling the circuit.
– Press the blue release ring down, after which the tubing can be pulled out.
Noise due to escaping compressed air
– Noise caused by escaping compressed air may damage your hearing. Reduce
noise by using mufflers, or wear hearing protection if noise cannot be avoided.
– All of the exhaust ports of the components included in the equipment set are
equipped with mufflers. Do not remove these mufflers.
To Next Page
Loading...
