7978
7
CONTURO KA 65 Accessories
Base runner scratch protector LAS-STF-KA 65
Base runner with fastener, 4 retaining screws, 3x felt pads.
X For using the edge bander on delicate or high-gloss surfaces
X With StickFix system for quick and easy replacement of the felt layer
Edging holder KSP-KA 65
For feeding in long or delicate edging. For a maximum edging height of 45 mm,
maximum edging thickness 2 mm.
X For the safe guidance of delicate and thin edging into the edge bander KA 65
X Safe guidance of long edges without damaging or soiling
X Max. edge lengths of 8 m (edge thickness of 2mm) possible
X Easy machine guidance, even along long edges
Trimming machine KP 65/2
Trimming height 65 mm, trimming thickness 2 mm. For trimming on the right and left
side as well as circular edging.
X Join trimming function (for round table) and trimming of panel edges
(final trimming) with a single machine
X For trimming plastic edging with a height of 18–65 mm and a thickness of 0.5 – 2.0
mm (depending on material)
X Ergonomic handle location for easy, effortless trimming, even on thick edging
X Patented eccentric fine adjustment for precision join trimming
X Tabletop on both sides of the trimming machine allows the user to trim left and
right panel edges from above - with a perfect view of the workpiece
Replacement felt EF-LAS-STF-KA 65 10x
10x replacement felt, for use with base runner scratch protector LAS-STF-KA 65
2014_FES_EN_CONTURO.indb 78 11.12.13 11:52
To Next Page
Loading...
