Finometer® Model-2 User’s Guide 13
3.5
The (optional) 3-lead ECG module 36
3.6 Finger cuff 37
3.7 Finometer® Model-2 Control 38
3.8 Connecting the Frontend Unit 39
3.9 Connecting the Height Correction Unit 39
3.10 Connecting the ECG (optional) 39
3.11 Connecting to a PC 40
4 Using the control keypad 41
4.1 Control keys 41
4.2 Finometer® Model-2 modes 42
4.2.1 Startup mode 42
4.2.2 Connect Frontend mode 44
4.2.3 Ready mode 44
4.2.4 Run mode 45
4.2.5 Error mode 47
5 Configuring the device 48
5.1 Height Correction Unit nulling procedure 48
5.1.1 Checking Height Correction Unit nulling 49
5.1.2 Performing a Height Correction Unit nulling procedure 49
5.2 Using the analog I/O cable 52
5.2.1 Definition of output signals 53
5.2.2 Analog signal input 54
5.3 Calibration options 54
5.3.1 Analog output calibration 54
5.4 Configuration option menu 55
5.4.1 Steady pressure calibration check 55
5.4.2 Waveform calibration output 56
5.4.3 Beeper configuration 57
5.4.4 Serial protocol 57
5.4.5 Software version 58
5.5 PC monitoring and recording with BeatScope® Easy 59
6 Performing a measurement 61
6.1 Using finger cuffs 61
6.1.1 Finger cuff selection 61
To Next Page
Loading...
