30 Finometer® Model-2 User’s Guide
Standard Finometer® Model-2 device:
• Main unit:
The central units of Finometer® Model-2 are contained in the main
unit housing. The main unit comprises a computer board and
electronics for the servo-controlled finger cuff pressure. The air
circuitry comprising a compressor and pressure control devices is
also part of the main unit.
• Frontend Unit:
A small box to be worn on the wrist accompanying finger cuff
connectors.
• AC power cord:
Country dependent type (see table on page 87).
• Finger cuff:
One M-cuff (beige, medium) and one S-cuff (white, small) is part of
the standard package. Finger cuffs are also available in one other
sizes: blue, L-size, large.
• Height Correction Unit:
A device to automatically correct for hydrostatic height changes
when the measured hand moves away from heart level. It allows
free hand movement during measurements with the device.
• Serial interface cable (RS232):
To connect the main unit to a PC or laptop with a RS232 (COM)
port for on-line recording and remote control of the device, using
the Beatscope® Easy software.
• USB/RS232 converter:
A converter to connect between the Serial interface cable and a PC
or laptop with a USB port, which have no RS232 (COM) port
available.
• BeatScope® Easy software (CDrom):
A program to monitor and record Finometer® Model-2
measurements on a PC and to view pressure waveform files.
Optional Finometer® Model-2 accessories:
• Analog I/O unit:
A separate box with five BNC connectors providing four analog
outputs and one analog input.
• ECG-module:
A standard 3-lead ECG providing an analog ECG signal as input to
Finometer® Model-2.
To Next Page
Loading...
