FireFlex TOTALPAC2 - General; Applicable Standards; Listings and Approvals; Environment

T OTAL P AC 2 Page 1 of 4
T OTAL P AC 2 Integrated Fire Protection System
General Section - Deluge System
FM-086G-0-15E
General
1. Applicable Standards
The T OTAL P AC 2 complies with the following standards:
- NFPA-13 Sprinkler Systems;
- NFPA-15 Water Spray Fixed Systems;
- NFPA-16 Foam-Water Deluge and Foam-Water Spray
Systems;
- NFPA-72 Fire Alarm Systems.
Before the installation, the contractor installing the unit shall
be familiar with the following documents and standards:
- Applicable Local & State Building Codes
- Any additional requirements of the Local Authority
Having Jurisdiction.
2. Listings and Approvals
In addition to being fabricated under tight ISO-9001
manufacturing and quality control procedures, your
T OTAL P AC 2 Unit has also been tested and approved by
recognized laboratories. Here is the list of Listings &
Approvals it meets:
- Underwriters Laboratories Inc. (UL): Deluge T OTAL P AC 2
systems are UL Listed under "Special System Water
Control Valves - Assembled Units, category
# VKYL.EX4641" and "Assembled Units Certified for
Canada, Category # VKYL7.EX4641 (C-UL)".
- Factory Mutual Research <FM>: Deluge T OTAL P AC 2
systems are FM Approved under the heading:
"Automatic Water Control Valves" when installed with
specific components.
California State Fire Marshal <CSFM>: Preaction
TotalPac2 systems are CSFM Approved under the
heading: Misc. Devices/Control Unit Accessories,
Listing No. 7300-0533:107.
- City of New York: Deluge TotalPac2 systems are
Approved under the Certificate of Approval # 6021.
(electric release only)
Note: Although most T OTAL P AC 2 units are Listed, custom
built units are sometimes supplied on request.
Components in these special units maintain their
individual Listings/Approvals but the units are not Listed
as an assembled unit.
CAUTION ! Any unauthorized modification or addition
made on-site to a factory built Listed Unit will void this
Listing. Such modifications or additions may void the
unit's warranty as well. Consult your nearest FireFlex
Systems Authorized Distributor before proceeding with
such modifications or additions.
3. Environment
T OTAL P AC 2 units shall be installed in a dry and clean
location. Verify that all equipment is properly heated and
protected to prevent freezing and physical damage.
The unit and it's components must be kept free of foreign
matter, freezing conditions, corrosive atmospheres,
contaminated water supplies, and any condition that
could impair its operation or damage the components.
The frequency of the inspections and maintenance will
vary depending on these environmental conditions. The
owner is responsible for maintaining the fire protection
system and devices in proper operating condition.
Refer to MECHANICAL DESCRIPTION for maintenance
instructions.