Fischer Panda 8000x - Set up the Optional DC Output of the CP-G

Panda xControl
10.6.16 Kapitel/Chapter 11: Panda xControl - Seite/Page 175
11.1.8.2 Set up the optional DC output of the CP-G
Scroll with the „Step-up“/“Step-down“ buttons to the menu point „optional DC output“ and confirm with the „Start/Stop
- Enter“ button. You enter the menu point optional DC output.
Fig. 11.1.8.2-1: Submenu „optional DC output“Choose „operation mode“ or „follow-up time“ and confirm
with the „Start/Stop - Enter“ button.
Choose cancel or confirm with the „Step-up“/“Step-down“
buttons and confirm with the „Start/Stop - Enter“ button.