Fischer Panda iControl3 User Manual

General operation
Seite/Page 18 - Kapitel/Chapter 3: General operation 20.10.22
3.4.1.3 Selecting the unit for temperature value outputs (»Units«)
Temperature values can be displayed in degrees Celsius [°C] or in degrees Fahrenheit [°F].
Fig. 3.4.1.3-1: Submenu »Panel«, highlighted *Units*• Select *Units* and confirm with the start/stop button.
Fig. 3.4.1.3-2: Selected unit, highlighted *Celsius*Settings options:
*Celsius*: Output of all temperatures in degrees Celsius [°C]
*Fahrenheit*: Output of all temperatures in degrees Fahren-
heit [°F]
3.4.1.4 Setting the network ID
Stop! Network ID must not be modifiedSettings in this area must only be entered by Fischer
Panda associates and Fischer Panda service points.
Changing the network ID can result in malfunction.
Fig. 3.4.1.4-1: Submenu »Panel«, highlighted *Network*• Select *Network* and confirm with the start/stop button.
Fig. 3.4.1.4-2: Screen for setting the network ID• Enter the network ID.

Fischer Panda iControl3 Specifications

General

Brand	Fischer Panda
Model	iControl3
Category	Controller
Language	English