Installation
Seite/Page 26 - Kapitel/Chapter 4: Installation 20.10.22
only an electrician may carry out the installation of the
electrical connections of the generator.
Warning! Hot surface/materialGenerator and cooling water may be hot during and after
operation. Burn/scalding hazard!
During operation, overpressure may build up in the cooling
system.
Mandatory instruction! Protective equipment
required
For installation work, personal protective equipment is
compulsory. This includes:
• Tightly fitting protective clothing
• Safety shoes
• Safety gloves
• Hearing protection
• Safety goggles if applicable
Warning! Switch off all loads.All loads must be disconnected prior to working on the
generator to avoid damage to the devices.
4.2 Disposal of the components
Mandatory instruction! Protect the environment.Electronics components are hazardous to the
environment and contain rare raw materials.
Collect and properly dispose of components that are no
longer needed!
The iControl3 board is typically pre-installed on the generator, and the corresponding connecting lines for connecting
it to the iControl3 panel and the PMGi are prepared. See generator manual.
To Next Page
Loading...
Need help?
General
