EasyManuals Logo

Fischer Panda iControl3 User Manual

Fischer Panda iControl3
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Safety instructions for the Panda iControl3
20.10.22 Kapitel/Chapter 2: Safety instructions for the Panda iControl3 - Seite/Page 3
2. Safety instructions for the Panda iControl3
2.1 Personnel
The settings described here can be performed by the operator unless highlighted differently.
The installation should be implemented by specially trained technical personnel or by authorised workshops (Fischer
Panda Service Points), only.
2.2 Safety instructions
Note!Ensure compliance with the safety instructions in the
Fischer Panda genset manual.
If these instructions are not on hand, they can be requested
from Fischer Panda GmbH, 33104 Paderborn, Germany.
Warning! Automatic start-upAn external signal may trigger an automatic start-up.
Warning!The generator must not be operated with the cover
removed.
If the generator is being installed without a sound insulation
capsule, it must be ensured that all rotating parts (belt pulley,
belts etc.) are covered and protected so that there is no
danger to life and body!
If a sound insulation capsule will be produced at the place of
installation, then well-placed signs must show that the
generator can only be switched on with the capsule closed.
All service, maintenance, or repair work may only be carried
out when the unit is not running.
Warning! Electric voltageElectric voltage - DANGER TO LIFE!
Electric voltages of more than 60V are potentially lethal in
any situation. The rules of the respective regional authority
must be adhered to for installation and maintenance.
For safety reasons, only an electrician may carry out the
installation of the electrical connections of the generator.
Warning!Disconnect battery before working on the generator
The battery must always be disconnected (first the negative
terminal, then the positive terminal) if work on the generator
or electrical system is to be carried out, so that the generator
cannot be unintentionally started.
This applies in particular to systems with an automatic start-
up function. The automatic start-up function shall be
deactivated before starting work.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fischer Panda iControl3 and is the answer not in the manual?

Fischer Panda iControl3 Specifications

General IconGeneral
BrandFischer Panda
ModeliControl3
CategoryController
LanguageEnglish

Related product manuals