EasyGrid User Guide MAN-00084 R 11.0
25
Select the original mode of operation of the relay
by pressing on the desired option. The active
option icon will then turn green .
Normal: The original relay position will be in the
Normally Closed (NC) position.
Fail Safe: The original relay position will be in the
Normally Opened (NO) position.
NOTE: After a parameter is created or modified, remember to press the button when prompted,
before leaving the active screen so that the parameter is stored or the action executed.
Select the source of information for the relay to
Trig On by pressing on the desired option. The
active option icon will then turn green .
T° Only: Relay will Trig On only from the
Temperature Setpoint parameters.
T° + Channel Fault: Relay will Trig On from the
Temperature Setpoint parameters or a Channel
Fault.
To Next Page
Loading...