EasyManua.ls Logo

FJDynamics FJDZ42P - Disassembling the Lithium-Ion Batteries; Installing the Lithium-Ion Batteries

FJDynamics FJDZ42P
93 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 54 -
©2022 FJDynamics. All rights reserved.
FJDZ42P Electric Zero-turn Mower User Manual
Reference: Read and understand all the safety warnings and instructions. Failure to
follow these suggestions may result in electrical shock or serious injury.
8.4 Disassembling the Lithium-ion Batteries
1. Turn over the seat to the limit.
2. Disconnect the seat sensor harness, loosen the two bolts on the battery compartment cover with
a wrench, and remove the battery compartment cover.
3. Ensure that all batteries are turned off, that is, the battery power switches are in the pop-up
position.
4. Disconnect all the battery harnesses.
5. Take all batteries out of the battery compartment at an angle of 25 degrees.
WARNING
Do not take apart the batteries. Exposure of the inner structure can damage the battery and
cause personal injury.
WARNING
Before maintaining the mower, press the start/stop button to power off the mower, and ensure
that the lithium-ion batteries are disconnected.
8.5 Installing the Lithium-ion Batteries
1. Put the batteries into the battery compartment under the seat.
2. Connect the battery harnesses.
3. Press the battery power switches to turn on all the batteries.
4. Close the battery compartment cover, and use a wrench to tighten the screws with a torque of
1825 N·m.
5. Connect the seat sensor harness, and put the seat back.
WARNING
Do not take apart the batteries. Exposure of the inner structure can damage the battery and
cause personal injury.

Table of Contents