FJDynamics FJDZ42P - Troubleshooting; Cutting Deck

- 72 -
©2022 FJDynamics. All rights reserved.
FJDZ42P Electric Zero-turn Mower User Manual
11 Troubleshooting
11.1 Cutting Deck
Contact your local dealer if you have any doubt.
Problem
Cause
Solution
The mower does not
discharge clippings properly.
The grass is wet.
Mow the grass after it dries.
The grass is tall.
Raise the cutting height, and
mow the grass twice.
The cutting height is low.
Raise the cutting height.
The driving speed is high.
Slow down the driving speed.
There are grass or debris
remaining on the ground
after mowing.
The driving speed is high.
Slow down the driving speed.
The grass is tall.
Raise the cutting height, and
mow the grass twice.
The blades are worn or
damaged.
Replace the blades.
The grass builds up within
the cutting deck.
Clean the inner side of the
cutting deck.
The mower cuts unevenly.
The driving speed is high.
Slow down the driving speed.
The blades are dull.
Sharpen the blades.
The blades are bent.
Replace the blades.
The cutting deck is not
leveled.
Level the deck as instructed in
the section "Adjusting the
Levelness and Height of the