FJDynamics FJDZ42P - Page 81

- 73 -
©2022 FJDynamics. All rights reserved.
FJDZ42P Electric Zero-turn Mower User Manual
Problem
Cause
Solution
Cutting Deck".
The blades are worn.
Replace the blades.
The anti-scalp wheels are
set incorrectly.
Adjust the height of the anti-
scalp wheels.
The tire pressure is low.
Inflate the tires to the normal
pressure.
The lawn is scalped, and the
soil is exposed.
The cutting height is low.
Raise the cutting height.
The turning speed is high.
Slow down the turning speed.
The ground is bumpy.
Change the mowing mode, such
as the mowing direction.
The blades are bent.
Replace the blades.
The tire pressure is low.
Inflate the tires to the normal
pressure.
The mower vibrates too
much.
The grass builds up within
the cutting deck.
Clean the cutting deck.
The blades are bent or out
of balance.
Replace or balance the blades.
The bolts fixing the blades
are loose.
Fasten the bolts.
The cutting deck is
overloaded.
The driving speed is high.
Slow down the driving speed.
The grass builds up on or
Clean the cutting deck.