FJDynamics FJDZ42P - Maintenance; Regular Maintenance

- 57 -
©2022 FJDynamics. All rights reserved.
FJDZ42P Electric Zero-turn Mower User Manual
9 Maintenance
Maintenance Service Interval
Maintenance Procedure
Daily or before each use
◾ Inspect the safety-interlock system.
◾ Visually check whether the tires are flat.
◾ Inspect the blades.
◾ Inspect the entire mower for damaged,
missing, or loose parts, such as the discharge
chute, screws, nuts, and bolts, ensuring that all
protections are in place and working properly.
After each use
◾ Clean the blades.
Every 25 hours
◾ Check the tire pressure.
Every 100 hours
◾ Check the rear wheels, ensuring that the nuts
are fastened at the recommended torque.
Every 200 hours
◾ Check the front wheels, ensuring that they can
turn freely.
Every 500 hours
◾ Change the drive axle reducer oil.
Before storage
◾ Fully charge the mower.
◾ Perform all maintenance procedures listed
above and thoroughly clean the mower.
◾ Inspect the entire mower for damaged,
missing, or loose parts, and replace or tighten the
corresponding ones before storage.
Annually
◾ Inspect the parking brake system. Place the lap
bars in the parking position. After powering off
the mower, push the mower to check whether it
can be moved. If the mower can be moved,
contact the local dealer.
◾ Add grease to the grease nipple.
9.1 Regular Maintenance
Regular maintenance is the best prevention. The following sections provide proper maintenance
suggestions and schedules that the operators should follow. Remain alert to unusual noises, as
they could be signaling a problem. Visually inspect the mower for any abnormal wear or damage.
When performing scheduled maintenance service, you can also detect potential problems. Inspect
the mower daily for grass clippings, and wire and string tangles. Grass clippings and dirt may
accumulate under the cutting deck, especially when the grass is wet or has high moisture content.