6. Q&A
Yes.
Q1: Is calibration required after nozzle replacement?
Method 1: Increasing the platform temperature can improve the adhesion between
the platform and the model.
Method 2: Adding a raft during model slicing can alleviate the issue.
Method 3: Apply glue.
Method 4: If the distance between the nozzle and platform is too large, reduce it
accordingly using the extruder calibration in the expert mode or the
leveling and calibration function.
Method 5: Check if the platform is level. The leveling and calibration function can
be used. It is recommended to complete the full auto-leveling process.
Q7: What to do if the printed model warps or doesn't adhere well?
Yes. You can use filaments from other brands, but certain parameter
adjustments are required due to slight temperature differences in different
filaments.
Q4: Can filaments from other brands be used?
Yes. This function can be enabled in the [Settings] interface.
Q5: Can the printer shut down automatically after printing is
completed?
ABS can release toxic gases during heating. It is recommended to use the HEPA
air filter during or after printing. If conditions permit, consider printing in a
well-ventilated area. It is recommended to print non-toxic materials such as
PLA in children's activity places.
Q6: Is it safe to print with ABS material?
1. Observe the filament guide tube to check if filament has entered the nozzle.
If not, please click [Load] until filament comes out.
2. Check if the nozzle is clogged. If so, please refer to Section 5.1.2 for the solution.
Q2: What to do if the extruder moves but doesn't extrude filament
at the beginning of printing after clicking the model for printing?
Please refer to Section 2.1 Equipment Calibration for the solution.
Q3: What to do if the nozzle position is too high (far from the
platform) or too low (hitting the platform) during printing?
How to level it?
36
To Next Page
Loading...
