FLENDER ZAPEX - 4 Application Planning; 4.1 Transport of the Coupling; 4.2 Storage of the Coupling

M3560-02en Edition 09/2022 23
Application planning
4
Check the delivery for damage and for completeness. Report any damage and/or missing
parts to Flender immediately.
The coupling is delivered in individual parts and preassembled groups.
4.1 Transport of the coupling4.1 Transport of the coupling
WARNING
Severe personal injury due to improper transport
Severe personal injury due to falling components or due to crushing. Damage to coupling
parts possible due to use of unsuitable means of transport.
• Only use hoisting gear and load lifting devices with sufficient load bearing capacity for
transport.
• The symbols which appear on the packaging must be observed.
If not specifically contractually agreed otherwise, the packaging complies with the HPE Pack-
aging Directive.
2EHQ=HUEUHFKOLFKHV
*XW
9RU1¦VVH
VFK¾W]HQ
9RU+LW]H
VFK¾W]HQ
6FKZHUSXQNW+DQGKDNHQ
YHUERWHQ
$QVFKODJHQ
Figure4-1:Transport symbols
4.2 Storage of the coupling4.2 Storage of the coupling
NOTICE
Property damage due to improper storage
Negative changes to the physical properties of the coupling and/or coupling damage.
• Please observe the procedure for storing the coupling.
The coupling, unless specifically ordered otherwise, is supplied with preservation and can be
stored for up to 3 months.
Information about storing the coupling
• Ensure that the storage room is dry (relative humidity < 65%) and free of dust.
• Ensure that there is no condensation.
• Do not store the coupling together with corrosive chemicals, acids, caustic solutions, etc.