FLENDER ZAPEX - A Technical Specifications; A.1 Speeds, Geometry Data and Weights

M3560-02en Edition 09/2022 61
Technical specifications
A
A.1 Speeds, geometry data and weights Speeds, geometry data and weights
In this chapter you can find dimension drawings and technical data for ZAPEX couplings of
the following types:
• Dimension drawing for ZNN and ZNNA (Page61) type
• Dimension drawing for ZNZS and ZNZA (Page62) type
• Dimension drawing for ZNNV (Page63) type
• Dimension drawing for ZNZV (Page64) type
• Dimension table (Page66)
A.1.1 Dimension drawing for ZNN and ZNNA types Speeds, geometry data and weights
The ZNNA type is only produced in variant A (S16). For clearance S1, S2, S3 and S16, refer
to Chapter Clearance S (Page66).
You can find the dimension table in Chapter Dimension table (Page66).

࢈%"
444
࢈% ࢈/%
࢈2 ࢈%
࢈%
࢈2 ࢈/% ࢈%
/-
11
/-


FigureA-1:Dimension drawing for ZNN types
① Variant A
② Variant AB
③ Variant B