FLENDER ZAPEX - Page 5

Table of contents
M3560-02en Edition 09/2022 5
11.2.3 Screw plug ...............................................................................................................................60
A Technical specifications ..........................................................................................................................61
A.1 Speeds, geometry data and weights........................................................................................61
A.1.1 Dimension drawing for ZNN and ZNNA types .........................................................................61
A.1.2 Dimension drawing for ZNZS and ZNZA types........................................................................62
A.1.3 Dimension drawing for ZNNV types.........................................................................................63
A.1.4 Dimension drawing for ZNZV types .........................................................................................64
A.1.5 Dimension table .......................................................................................................................66
A.2 Clearance S .............................................................................................................................66
A.3 Distances between teeth VA and recommended alignment values for angular and radial mis-
alignment .................................................................................................................................67
A.4 Tightening torques and widths A/F ..........................................................................................68
A.5 Tightening procedure ...............................................................................................................69
A.6 O-rings .....................................................................................................................................69
A.6.1 Use and storage of the O-rings (12) ........................................................................................69
A.6.2 O-rings .....................................................................................................................................70
B Declaration of conformity ........................................................................................................................71
B.1 UK Declaration of Conformity ..................................................................................................71