FlexRadio FLEX-6000 Signature Series User Manual

FLEX-6000 Signature Series – Maestro User Guide
Page 158
Copyright 2019 FlexRadio Systems. All Rights Reserved.
33.2 SLICE RECEIVER TUNING KNOBS AND BUTTONS
The Maestro front panel provides two knobs and two sets of buttons for tuning Slice Receivers.
The larger of the knobs, to the left, tunes the A Slice Receiver while the smaller of the knobs, to the
right, tunes the B Slice Receiver. Tuning is completely independent. Each knob generates 64 tuning
pulses per rotation and each pulse moves the frequency by an amount determined by the Slice
Receiver’s frequency step size and the direction of rotation of the knob.
Pressing the A or B Step button pops up a display of the step size in Hertz. Repeated presses cycle
through a range of steps appropriate to the Slice Receiver’s mode. Pressing and holding the button
causes the step size to cycle in reverse.
The A and B Lock buttons lock the frequency of the corresponding Slice Receivers so that any attempt
to change the frequency is ignored. When the frequency is locked, the button illuminates in red.

FlexRadio FLEX-6000 Signature Series Specifications

General

Brand	FlexRadio
Model	FLEX-6000 Signature Series
Category	Control Unit
Language	English