FlexRadio FLEX-6000 Signature Series User Manual

FLEX-6000 Signature Series – Maestro User Guide
Page 61
Copyright 2019 FlexRadio Systems. All Rights Reserved.
Persistence remembers a large number of settings as shown in the following table:
Radio
PTT Timeout
Show mic meter in receive
TX1/2/3/Acc enabled and delay
Show transmit signals in Waterfall
TXREQ enabled and polarity (RCA & ACC)
DAX transmit enabled
Speaker volume and mute
Hardware ALC enabled
Headphone volume and mute
Transmit inhibit setting
PC Audio enabled
VOX Level and hang time
Processor enabled and setting
Raw I/Q mode enabled
Selected microphone
Transmit filter passband (low, high)
CW/CWX Keyer speed
AM Carrier Level
CW/CWX breakin delay
CW Sideband (CWL or CWU)
CW Pitch
CW Iambic mode / straight key
CW Monitor enabled / level / pan
CW/CWX synchronize settings enable
SSB monitor enabled / level / pan
Reference calibration offset
Mode
Selected microphone
Microphone
Bias enabled
Level
Boost enabled
Compander settings
Accessory Mix enabled
Slice
Frequency
AGC Mode
Filter limits
AGC-Threshold / AGC Off Level
Mode (USB, CW, etc.)
Mute state
RX Antenna
Audio level, pan
TX Antenna
WNB, NR, ANF, APF states and levels
TX state (is this the transmit Slice?)
Diversity state / Slice
DAX channel
FM tone mode
Squelch settings (for FM)
FM repeater offset
Panadapter
Center Frequency and Bandwidth
DAX I/Q Channel
RX Antenna and Loop settings
Display frames per second
Preamplifier setting
Display averaging settings
Display min/max dBm
Waterfall
Auto-black enable and level
Gradient selection
Scroll speed (line duration)
Color gain

FlexRadio FLEX-6000 Signature Series Specifications

General

Brand	FlexRadio
Model	FLEX-6000 Signature Series
Category	Control Unit
Language	English