FLEX-6000 Signature Series – Maestro User Guide
Page 84
Copyright 2019 FlexRadio Systems. All Rights Reserved.
• Mode - The Modulation/Demodulation mode for the Slice (e.g. USB, CW, FM, etc.). Initially
set to the Active Slice mode.
• Step – The frequency step size in Hertz, associated with this setting.
• OffsetDirection - If in FM mode, this sets the direction for the repeater transmitter offset.
Options are Down, Simplex and Up. Initially this will be set to the matching setting in the
Active Slice.
• RepeatersOffset - The offset in MHz. Initially this will be set to the matching setting in the
Active Slice.
• ToneMode - In FM transmit, this can be set to Off or CTCSS TX for PL tones. Initially this will
be set to the matching setting in the Active Slice.
• ToneValue - The tone value in Hz to use for CTCSS TX
• Squelch – Turns FM Squelch on or off.
• Squelch Level – The Squelch threshold value.
• RF Power - The power setting from 0-100 to use for this memory.
• RX Filter Low - The Receive Filter Low Cut in Hz
• RX Filter High - the Receive Filter High Cut in Hz
• RTTY Mark - The mark frequency when using RTTY mode
• RTTY Shift - The shift frequency when using RTTY mode
• DIGL Offset - The offset when using DIGL mode
• DIGU Offset - The offset when using DIGU mode
Note: Memories and Profiles are two separate features that may appear similar. However,
memories record a relatively small number of radio configuration parameters, as listed above,
while Profiles record many more parameters.
To Next Page
Loading...
