Flintec FT-107 - Installation Parts; Parts Included for FT-107; Part Included for FT-107 S

FT-107 Weighing Terminal, Technical Manual, Rev. 1.0.0, August 2019 Page 10 of 46
3.4 Installation Parts
3.4.1 Parts included for FT-107
FT-107 Indicator
100VAC - 240VAC, 50 – 60 Hz / 12VDC, 0.8A regulated adapter.
Support plate
(will be mounted on the rear of the indicator)
Column holder
(will be mounted on the support plate)
Wall mounting plate
(will be mounted on the column holder)
Battery BAT21 Li-ion
Sealing kit for sealing with lead
(only approved versions)
1 x Load cell connector
4 x rubber foot for usage on the table
3 x M4 screw for installation to Support plate
2 x allen screws for installation to Column holder
3.4.2 Part included for FT-107S
FT-107S Indicator
Column holder
(will be mounted on the rear of the indicator)
Wall mounting plate
(will be mounted on the column holder)
Battery BAT21 Li-ion
2 x allen screw to install on the indicator support 2