Flintec FT-107 - Exiting the Programming and Calibration

FT-107 Weighing Terminal, Technical Manual, Rev. 1.0.0, August 2019 Page 36 of 46
7.2 Exiting the Programming and Calibration
With the Esc key the menu block can be left. Follow the diagram below to return to the operation from set-
up.
Display
Operation
[ item ]
For example [ ZrnG ]
Press Esc key to return to the main block.
[ block ]
For example [ bUıLd ]
Press Esc key to leave the set-up.
[ SAVE ]
Press Enter key to save the set-up.
Press Esc key to return to operation without saving.