FT-107 Weighing Terminal, Technical Manual, Rev. 1.0.0, August 2019 Page 12 of 46
4.2 Housing
4.3 Mechanical Installation
You may install your weighing indicator on a column, on a table or on a wall. Take care of the housing
drawings and dimensions given in this manual to design your weighing scale or weighing station mechanically.
Be sure that the mechanical installation of the instrument is done properly for long time life before starting
electrical installation as descripted below. Installation of the desk type and wall type housings are identical due
to same kits usage as shown below.
If the indicator will be used on the table, stick the 4 pieces
rubber foots on the back of the indicator (only FT-107).
For installation on a round scale column, do not stick the
rubber foot and follow the pictures below.
Install the Support plate to the indicator with 3 pcs M4 screws included
in the box (only FT-107).
Install the Column holder after installing 2 allen screws.
If the indicator will be mounted on the square column or to the
wall, install the wall mounting plate to the column holder
To Next Page
Loading...
