FT-107 Weighing Terminal, Technical Manual, Rev. 1.0.0, August 2019 Page 9 of 46
3.3.2 Key Pad
The keys and the key functions of FT-107(S) in usage are:
Power on/off key: Press button to turn it on. To turn it off, press the button for
one second.
* key: The most frequent used function key. Press to use the selected function.
(Page 23)
Sampling key: Press the * key more than one second to start sampling in
piece counting.
(Page 29)
Escape key: In menu mode, press this key to escape from menu and return to
normal mode.
Tare key: Press this key to deduct the weight of the container placed on the
platform to see the net weight value of the added material in the container or
taken out material from the container.
(Page 25)
Checkweighing key: To enter check weighing operation press this key until
[ H-L : n ] message appears.
(Page 32)
Zero key: This key adjusts the scale zero, if there is any drift. Zeroing should
be done if there is no load on the platform.
(Page 17)
F key: This key is used for its programmed function usage.
(Page 23)
ADV key: This key is used to enter advance functions setting by pressing more
than one second.
(Page 19)
M+ Add to memory key: Press this key to add the indicated weight to the
accumulator in weighing and in counting operations.
(Page 18 in weighing and page 30 in piece counting)
MR Memory read: Press this key to indicate accumulated total weight in
weighing operation or accumulated quantity in piece counting operation.
(Page 18 in weighing and page 30 in piece counting)
MC Memory clear key: Press this key to erase accumulated value from
memory. The weight and count accumulators shall be erased separately.
(Page 18 in weighing and page 30 in piece counting)
Enter key: Press this key for printout.
Navigation keys: Navigation keys are located on the right of the indicator
front which are up, down, left and right arrow keys. These keys are used for
navigation in set up and to change any numerical value.
Calibration switch is located on the rear of the
instrument. The calibration switch should be
sealed before putting the scale in to usage.
To Next Page
Loading...
