Flintec FT-107 - Programming and Parameters; Oiml: 0 ] Oiml; Incr: 0 ] Increased Display Resolution; Zrng: 1 ] Zero Range

FT-107 Weighing Terminal, Technical Manual, Rev. 1.0.0, August 2019 Page 38 of 46
7.4 Programming and Parameters
[ Build ] Scale Build Block
The scale is defined with the following parameters. Press Enter key to enter the block or press ► key to
enter the next block or press Esc key to return to the operation (Page 36 ).
7.4.1 [ OIML: 0 ] OIML
O
Non-OIML scale application.
1
Approved scale.
This parameter should be selected as ‘ 1 ’ for approved scales to activate the calibration switch for
securing the sealing.
Press ▲ key to change the value. Press Enter key to enter the next item or press
Esc key to return to the main block.
7.4.2 [ InCr : 0 ] Increased Display Resolution
O
Weight indication.
1
x10 times increased resolution.
Press ▲ key to change the value. Press Enter key to enter the next item or press
Esc key to return to the main block.
7.4.3 [ ZrnG: 1 ] Zero Range
This parameter sets the zeroing range by pressing the Zero key.
O
Disable
1
±2% of the scale range
2
±10% of the scale range
3
±50% of the scale range
Press ▲ key to change the value. Press Enter key to enter the next item or press
Esc key to return to the main block.
7.4.4 [ PZer: 1 ] Power on Zero Range
This parameter sets the zeroing range at power on.
O
Disable
1
±2% of the scale range
([E E E] prompt cannot be erased. Call service)
2
±10% of the scale range
3
±20% of the scale range
Press ▲ key to change the value. Press Enter key to enter the next item or press
Esc key to return to the main block.
7.4.5 [ AZT : 1 ] Automatic Zero Tracking
This parameter sets the AZT against small zero drifts against environmental affects like rain, snowing
and dust etc.
O
Disable
1
±0.5 e
2
±1 e
3
±3 e
Press ▲ key to change the value. Press Enter key to enter to next item or press
Esc key to return to the main block.