FT-107 Weighing Terminal, Technical Manual, Rev. 1.0.0, August 2019 Page 33 of 46
6. Place an object on the platform and the checkweighing bar is activated after loading the platform as
shown below.
To return from checkweighing function to basic weighing, press H-L key for a while, change the H-L item
value to “n” and press Enter key. The checkweighing bar will be disabled.
Checking the quantity at piece counting (+/-)
This feature is used for checking if the quantity is in tolerance at piece counting mode. The back-light color
changes automatically if weighing to indicate the load is under, okay or over. Refer to page 22 to adjust this
feature.
1. Press H-L key longer than one second in piece counting mode until the message below appears.
The letter on the right indicates the check weighing is enabled or not.
2. To enable the checking operation, press ▲ key, select “ Y “ and then press Enter key.
3. The ALU memory number appears on the display as [ ALU :01 ]
4. Change the ALU record number by using navigation keys and press the Enter key to start operation
or press Esc key to return to the operation without saving the ALU code.
5. The values Target, Hi and Lo display automatically before check piece operation.
6. Place an object on the platform and the check piece bar is activated after loading the platform as
shown below.
To disable from checkingweighing function, press H-L key for a while, change the H-L item value to “n” and
press Enter key.
Double sided display scale for multi operator
FT-107(S) can be programmed as “Remote” instrument and then connected to the weighing indicator over
RS232 port. Double sided display / keypad scale can be configured by using a weighing scale and a remote
instrument.
To Next Page
Loading...
