Issue 13 CWT Compact Touch Installation and Maintenanace Manual Page 37
• The ink shall not smear while wound up on the supply roll, or during the
printing process.
• Ink used for preprinting in the black mark zone and in the centre of the paper
on the non-thermal side shall have no influence on the reflective IR-sensor.
OCR-blind ink shall be used.
Print side
preprint is not recommended in the black mark zone on the inner side unless the
above conditions are met.
Paper low sensor area
No preprint is allowed on any side of the paper in a 2-mm wide area from the
edge of the roll.
4.6.3 Black mark location
The GeBe printer uses a different location for the black mark the Zebra printer in
older machines.
Verify that you use the correct type of paper.
Warning:
When using black mark, you cannot use rolls for a Zebra printer in a GeBe printer
as the black marks are on different locations on the paper
To Next Page
Loading...