ROTADISK Pneumatic Actuator RD & RDF
Operating Manual – BA3002 EN
2 Safety Information
Page 24 of 79
2.5 Qualification of the Personnel
The personnel of the owner company who are entrusted to work on the ROTADISK
Pneumatic Actuator must have suitable knowledge and skills as well as satisfying the
following prerequisites:
▪
Adequate qualification and personal aptitude for the respective activity.
▪
Successfully completed user training for supervised or unsupervised work with the
ROTADISK Pneumatic Actuator.
▪
Knowledge of the personal protective equipment (PPE) and its correct use.
▪
Knowledge of this operating manual and especially knowledge of the safety messages
and the chapters relevant to the activities to be performed.
▪
Knowledge of the basic directives/regulations regarding health and safety and
prevention of accidents.
2.6 Target Groups
This operating manual is intended for the following target groups:
2.6.1 Owner Company Management
The management of the owner company makes compliance and management decisions
and can be held responsible for their decisions.
2.6.2 Specialists
Specialists have completed special technical training and have knowledge and
experience of the relevant work requirements and suitable work equipment. Specialists are
able to carry out the tasks assigned to them independently and to recognise and avoid
possible work-related hazards.
2.6.3 Instructed Workers
Instructed workers have received instruction from the owner company in all the work to be
performed and the work-related hazards.
To Next Page
Loading...
Need help?
General
